Home > News > Content

Contact Us

Add: 4F BuildingG,Xinhui Industrial Zone,Tangtou Industrial Park,Shiyan Town,Baoan District,Shenzhen,China

Zip: 518108

Tel: 86-755-29680608

Fax: 86-755-29680609

E-mail: annie@todaycnc.com

Engraving Machine Maintenance
Jan 27, 2016

Continuous running time below 10 hours a day, keep the water clean, and normal water pump work, 

spindle motor must not be water occurred water shortages regularly replace the cooling water 

to prevent the water temperature is too high. In winter if the operating temperature is 

too low the water tank with antifreeze.

Each time the machine after use, pay attention to clean, be sure to clean up the dust on the 

platforms and transmission systems, regular (weekly), the transmission system (x, y, z axes) 

lubricating oil. (Note: x, y, z axis light rod oil maintenance; screw part of the 

butter at high speed in winter if the operating temperature is too low, PRTT ball screw, 

Rod (square rails or circular rail) parts should first be washed clean with gasoline, 

then add oil, otherwise the machine will drive part of the resistance as a result of 

displacement of the machine. )

Appliance maintenance check, be sure to cut the power, nothing displayed on the monitor and 

the main circuit power supply led is off, can be carried out.

Engraving machine uses about three months to check your fasteners, gantry on both sides

of the connecting screws, screw nut fastening screws, for fastening on both sides of the fastening

screws of the motor